Sprayed polyurethane foam has an aged R-value of approximately 6.0 per 1 inch thickness (depending on the particular formulation and application, higher values have been achieved), enabling it to provide more thermal resistance with less material than any other type of commercial insulation material. SPF systems are frequently used to insulate and protect a wide variety of residential, commercial, and industrial buildings. Monthly energy and utility savings of 30% or greater have been reported by consumers.
Studies have shown that as much as 40% of a building's total energy loss is due to air infiltration. Traditional fiberglass insulation is only stapled, or placed into the wall cavities and does not seal the stud and wall cavities from end to end, or top to bottom. Air infiltration can pass through these gaps, making it far less efficient than SPF. SPF not only adheres to, but forms to the walls and floors to create a tight seal and insulating barrier that stops this air leakage. SPF also boasts the highest R-value per inch than any other commercial material, (upwards of R-7.0, compared with Fiberglass at R-3.5) making your home more comfortable and less expensive to heat in the winter, and cool in the summer.
Since SPF acts as an air barrier, it also helps to reduce moisture infiltration, which is a source of dangerous mold and mildew growth in the home, and can cause severe health problems to its occupants. So save your family and save money at the same time with SPF home insulation systems. Moisture infiltration can also cause structural damage to your home or building.
How can properly a properly insulated attic save you money on energy bills?
Prevent cold air, warm air, contaminatants from entering your IN home.
Learn all about closed-cell and open-cell foam and the properties, benefits, and uses for each.
What causes ice dams? How can you prevent them? You can start with foam insulation.
Spray foam reinforces both the studs and the exterior sheathing inside the walls.
How can you can you control temperature, movement of air, and moisture both into and out of a home?
SPF home insulation saves on energy costs and lowers utility bills. SPF is used to seal the entire “building envelope” of your home to prevent air and moisture infiltration. The US Department of Energy (DOE) studies show that 40% of your home’s energy is lost due to air infiltration. This air infiltrates the home in the form of drafts through walls sockets, windows and doorways. Often times no expensive building wrap or additional vapor protection is required during construction when using SPF, saving money yet again.
Spray foam is the fastest growing insulation material on the market because it lowers energy bills and improves occupant comfort. Our experienced IN contractors install foam insulation in and around the state of Indiana. Find out more about getting SPF installed in your home here.Download the FREE Guide Now